Toe Board
My courseAsk Kick AIFree practice checksCHSTCoursesCHST courseGuidesAll guidesThe CHST exam outline: four domains and their weightsOSHA fall protection (Subpart M) for the CHSTOSHA excavations (Subpart P) for the CHSTOSHA scaffolds (Subpart L) for the CHSTOSHA electrical (Subpart K) for the CHSTOSHA cranes and derricks (Subpart CC) for the CHSTOSHA ladders and stairways (Subpart X) for the CHSTOSHA confined spaces (Subpart AA) for the CHSTOSHA health hazards: silica, lead and noise for the CHSTOSHA recordkeeping (Part 1904) for the CHSTCHST exam cost, fees and schedulingCHST eligibility: the experience BCSP asks forCHST exam results, retakes and renewalFree CHST practice test with explained answersCHST study guide: a six-week plan by domainCHST vs CSP vs ASP: which BCSP exam?Toe BoardCompare study optionsFor employersThe appAbout and editorial policy

OSHA scaffolds (Subpart L) for the CHST

Toe Board editorial teamSources checked 3 min read

Scaffolds put a workplace in the air, so they combine falls, struck-by and collapse in one structure. Subpart L (29 CFR 1926.450 to 1926.454) covers them in detail. The CHST blueprint lists working at heights, material handling and struck-by hazards in Domain 1. This guide gives the section map and the points the exam favors, in our own words.

Check anything you rely on against your own licensed code book and the edition your AHJ enforces.

Where Subpart L sits in the blueprint

Domain 1 is 36.6% of the CHST. Scaffold questions usually test who decides what (the competent person) and which number applies (10 feet, the capacity factor, power line clearance), rather than the names of parts.

The sections to know

  • 1926.450 covers scope, application and definitions.
  • 1926.451 holds the general requirements. Its key points: a scaffold and its components must support their own weight plus at least four times the maximum intended load. Platforms are fully planked, with the width and gap rules in paragraph (b). Fall protection is required above 10 feet, by guardrails or a personal fall arrest system depending on the scaffold type, in paragraph (g). Safe access is required (paragraph (e)). Falling object protection is required where something could fall on people below (paragraph (h)).
  • 1926.451(f) sets the use rules: a competent person inspects the scaffold before each work shift and after anything that could affect its structure, and scaffolds are not loaded beyond capacity or moved with workers on them. Clearance from energized power lines is a table in 1926.451(f)(6), and the figures grow with voltage.
  • 1926.452 gives extra rules by scaffold type: pole, tube and coupler, fabricated frame, suspension, mobile and others.
  • 1926.453 covers aerial lifts, which the exam may mix in with scaffold questions.
  • 1926.454 requires training: workers using scaffolds must be trained to recognize the hazards, and those who erect or dismantle them need training in the procedures.

Try one question

Question 1 of the free 10-question check on CHST. No signup.

Question 1 of 10 · free checkUntimed

Emergency Preparedness, Incident Investigation, and Response

On a building under construction, what is the longest allowed travel distance from any point of the protected area to the nearest fire extinguisher?

Choose an answer to begin

Who does what

A competent person oversees erection, moving, alteration and dismantling, with a qualified person's design where the rule requires one. Users do not alter the scaffold. A competent person also inspects before every shift, and that is a repeated duty, not a one-time check at erection.

Common mix-ups

  • 10 feet is the scaffold trigger. The general fall trigger is 6 feet. Match the number to the work.
  • Capacity is a safety factor. The structure must carry a multiple of the load, so a scaffold at its rated load is not at its breaking point.
  • Inspect before each shift. One inspection at the start of the job is not enough.
  • Guardrails depend on type. Some scaffolds allow a personal fall arrest system in place of rails: read the paragraph for the type in the question.

How to practice

Pick three scaffold types and write the fall protection rule, access rule and inspection rule for each. Work questions that give a height and a scaffold type and ask what protection is needed.

Related guides: fall protection (Subpart M), electrical (Subpart K) and ladders (Subpart X).

Practice it

Take the free 10-question check. It covers the four CHST domains, needs no signup and explains every answer, so you see whether this subpart is a weak spot. The CHST study guide shows where it fits in a six-week plan.

Not affiliated with or endorsed by BCSP.

Sources

Show the list

Ready to see where you stand on CHST?

Free, untimed and scored by domain. No signup.

Start the free 10-question check

Facts checked 24 October 2026 against the sources listed above. If something has changed, tell us and we will correct it within 2 business days.

Test yourself on this domainTake a free check weighted to the published outline and see your score by domain.

Start the free check

Your next step

  1. 01Free CHST check10 questions, untimed, about 12 minutes. Answers explained as you go.Start free
  2. 02Free sample lessonFall protection on a construction site: a full lesson from the course, plus 5 practice questions with explanations.Read the sample
  3. 03CHST course$149. Lessons, timed practice exams and a plan around your exam date.See the plans

The CHST course

Available now · instant access

Learn each CHST blueprint domain, then prove it on a full-length timed practice exam.

  • 4modules of lessonsEvery task on the outline
  • 1full-length timed exams200 questions in 240 minutes each
  • 300practice questionsEach one explained
  • 1week-by-week study planSet to your exam date

Turn a practice answer into a study step. In untimed practice, ask Kick AI about any question you answer, follow up, then see your weakest topics and what to drill next.

CHST course$149Get the CHST course · $149

Instant access. Terms and refunds.

Every answer comes with a full explanation.

Study guideOSHA fall protection (Subpart M) for the CHSTStudy guideOSHA excavations (Subpart P) for the CHSTStudy guideOSHA electrical (Subpart K) for the CHSTStudy guideOSHA cranes and derricks (Subpart CC) for the CHSTStudy guideOSHA ladders and stairways (Subpart X) for the CHSTStudy guideOSHA confined spaces (Subpart AA) for the CHSTStudy guideOSHA health hazards: silica, lead and noise for the CHSTStudy guideOSHA recordkeeping (Part 1904) for the CHST